45AH Outdoor IP65 60w solar powered street lights

1. Wide power range: 10W~60W.

2. Special circuit design, single LED damage won't affect others' normal work.

3. High Lumen output up to 145lm/ w with high-quality LED chips.

4. Lithium battery improves the reliability of the luminaire.

5. Monocrystalline silicon solar panels, greatly improving solar energy conversion efficiency.

6. Smart MPPT controller realizes intelligent control of lamps.

7. Multiple lighting control options are available, e.g. motion sensor, and PIR sensor.

Model	ZGSM-PV1006045
LED Number	90units
Nominal Power	60W
Battery Spec.	45AH /11.1V
Solar Panel Spec.	Monocrystal 100W /18V
LED Brand	Philips Lumileds 3030 2D
Luminous Flux	7800lm
Light type	1S
CCT	3000K.4000K.5000K.5700K
Charge time	<5 Hours (Low battery voltage)
Worktime at Energy -saving Model(30%)	more than 22 hours
Discharge Temperature	-20℃~+60℃
Charge temperature	<60℃
Light control voltage	5-11V
mounting height	6-8m
space between light	18-35m
Pole Diameter Fixture	Round pole: Φ60~85mm; Square pole : 60 x60 ~77 x77mm
Rating	IP65 IK10
Induction Type	Human infrared induction or microwave induction function
Certification	CE, ROHS, LM80
warranty period	3 years

Can street lights be powered by solar energy?

A solar street lamp is a raised light source powered by a solar panel, usually mounted on a lighting structure or integrated into the light pole itself. Solar panels charge a rechargeable battery that powers fluorescent or LED lights at night.

Are there motion sensor street lights?

Motion sensor street lighting control system with the radar-type sensor. A smart motion sensor street lighting control system that automatically activates when a car or pedestrian is noticed in the area. If there is no activity in the area, the light is automatically adjusted to the lowest optimized light level.

How do I turn off the motion sensor on the solar lamp?

Most manufacturers make this major feature of disabling lights a fairly simple process. The switch on the fixture should appear as "on time", usually located just below the motion sensor. Set it anywhere except the test position, and then turn off the switch to which the light is connected.